August 16, 2013This continues our report from 8/14/2013 about the creation of bronze bells.Before reassembling the flask, the artisans use a hollow metal tube to perforate the top of the negative bell impression and then, using a spoon, they carve a small concave circle around the top of the bell, as we see Rawaf doing in the picture to the left. This allows for a smoother pouring of the bronze into the mold.[photos and text by Soleri archive intern Julia Dorn-Giarmoleo]In the meantime, the furnace where the bronze is melted gets loaded up. Here is Andy putting unusable bells and other pieces of scrap bronze in the furnace to be melted down and re-used.The two sides of the flask are then reassembled, the wooden flask is taken off and the molds are lined up on the ground. A metal or plastic frame is then put around the sand mold, as Jonas is pictured doing in this photo. Ingots are then placed on the molds to prevent any possible movement.Two artisans, (pictured here are Andy and Jonas) don protective clothing, and lift the crucible containing the molten bronze out of the furnace.They carefully pour the bronze into each of the molds. The other artisans follow the pouring with shovels, so that should any bronze fall onto the cement or out of the mold, they can quickly throw sand on it to prevent any danger or injury.The molds are then left to cool for about an hour, or until the bronze is solidified. This report will continue on Monday.